Product Data SheetEdition 6, Version no. Sika Chapdur® -Premix Construction Non-Metallic Floor Hardene. Find out all of the information about the Sika France SAS product: hardener admixture / for floors / for flooring screed / for concrete SIKA® CHAPDUR® PREMIX. CHAPDUR® PREMIX Gray is a surface hardener for concrete floors.
|Published (Last):||18 May 2013|
|PDF File Size:||17.8 Mb|
|ePub File Size:||7.27 Mb|
|Price:||Free* [*Free Regsitration Required]|
Chapdur Premix shall be broadcasted evenly over the still fresh but stiff concrete. Remove contaminated clothing pfemix. Users should always refer to the most recent issue of the Technical Data Sheet for the product concerned, copies of which will be supplied on request, or can be accessed on the internet under www.
Care should be taken to ensure that the slab is laid accurately to finish profile and that excess water and laitance build up is kept to a minimum.
Chapdur® Premix Gray
Remove affected person to fresh air immediately and contact a physician. Once the Chapdur Premix has been evenly moistened lremix the concrete water, compact the floor with a low speed mechanical trowel. As surface areas at edges and adjacent joints are subjected chapdurr heavier impact and wear, additional treatment should be considered for these areas.
The proprietary rights of third parties must be observed. The Company reserves itself the right to change the formulation of Sika products if so required by new research and development. Wash hands immediately after use.
When Chapdur Premix is applied too early, water needed for hydration of the concrete will be absorbed and this may affect the strength of the concrete surface layer. Once the base concrete slab is levelled, sprinkle Chapdur Premix along the edges and compact chxpdur the surface using a steel trowel.
Sika Chapdur Premix – Interiors Centre
Contact Sika for further health and safety information. A common rule-ofthumb practice is when light foot traffic leaves a 3 – 5mm imprint. Chapdur Premix is a ready to use blend of graded hard aggregates of mineral origin, pigments and Portland Cement.
Remove uncured Chapdur Premix from tools and equipment with water immediately after ppremix. When Chapdur Premix is applied too late, there will be insufficient moisture from the concrete to complete the hydration process of Chapdur Premix and may cause crazing or pitting.
Flush immediately with water for 10 – 15 minutes and contact a physician immediately.
Chapdur® Premix Gray – Soil and finishing works – Hammami Counter Tunisia
Wash clothing before re-use. Apply 0,6kg per lineal metre over a width of mm.
In practice, the differences in materials, substrates and actual site conditions are such that no warranty in respect of merchantability or of fitness for a particular purpose, nor any liability arising out of any legal relationship whatsoever, can be inferred either from this information, or from any written recommendations, or from any other advice offered.
Cured material can only be removed mechanically. Collect with suitable absorbent material. Timing for application is crucial.
Do not overwork the Chapdur Premix and do not spray water to wet out surfaces treated with Chapdur Premix. Warehouses Engineering workshops Car parks, garages, service stations Quays Factories.
The base concrete shall be laid and compacted in accordance with good concrete practice with particular attention to bay edges and corners. Chapdur Premix is used as a dry shake, nonmetallic surface hardener for new concrete floor slabs and screeds where good abrasion resistance and reduced dusting is required, such as in: Chapdur Premix contains Portland Cement, Silica, and other graded aggregates. The Chapdur Premix surface must be protected to prevent rapid water loss which may result in surface cracks.
Dispose of in accordance with local regulations. All orders are accepted subject to our current terms of sale and delivery which are available on request. Use of safety goggles and chemical resistant gloves are recommended. Wash thoroughly with soap and water.